Slim Body Analog Fiber Sensor FX-11A

Panasonic's Slim Body Analog Fiber Sensor FX-11A is a slim body analog fiber amplifier that allows for 1-5Vdc output when using Fiber optic sensing solutions.
                                   
 Characteristics:

  • This Fiber Amplifier Incorporates An Analog Voltage Output Of 1-5V
  • The Slim Designed Body Of 10mm Thick, Allows For Space Savings On Any Din Rail Configuration  
  • A Built-In Interference Prevention Function Is Used When Two Are Mounted In Close Proximity  
  • This Amplifier Also Has A Saturation Indicator When The Output Reaches 5V, Allowing Sensitivity Adjustments Without A Tester

Part Number List

Results 1
Models table for series Slim Body Analog Fiber Sensor FX-11A
Part No.DatasheetSupply Voltage Current ConsumptionAnalog OutputResponse TimeIncident Beam IndicatorSaturation Indicator Sensitivity AdjusterInterference Prevention FunctionAmbient TemperatureAmbient HumidityAmbient IlluminanceVoltage WithstandabilityInsulation Resistance Vibration ResistanceShock ResistanceEmitting ElementMaterialCableCable ExtensionWeight (Typ.)Accessory
12 to 24 V DC ± 10 % Ripple P-P 10 % or less
35 mA or less
Analog voltage
・Output voltage: 1 to 5 V (proportional to incident light intensity)
・Output current: 5 mA or less
・Output impedance: 47 Ω
・Load resistance: 2 kΩ or more
・Temperature characteristics: 0.3 % F.S./℃ or less
Switchable either 1 ms or less, or 10 ms or less
Red LED (brightens up in proportion to analog output voltage)
Green LED (lights up when the analog output voltage reaches 5 V)
8-turn potentiometer with indicator
Incorporated
-10 to +55 ℃ +14 to +131 ℉ (No dew condensation or icing allowed), Storage: -20 to +70 ℃ -4 to +158 ℉
35 to 85 % RH, Storage: 35 to 85 % RH
Incandescent light: 1,000 lx at the light-receiving face
1,000 V AC for one min. between all supply terminals connected together and enclosure
(Note):The voltage withstandability and the insulation resistance values given in the above table are for the amplifier only.
20 MΩ, or more, with 250 V DC megger between all supply terminals connected together and enclosure
(Note):The voltage withstandability and the insulation resistance values given in the above table are for the amplifier only.
10 to 150 Hz frequency, 0.75 mm 0.030 in amplitude in X, Y and Z directions for two hours each
100 m/s2 acceleration (10 G approx.) in X, Y and Z directions for five times each
Red LED (Peak emission wavelength: 660 nm 0.026 mil, modulated)
Enclosure: Heat-resistant ABS, Case cover: Polycarbonate, Fiber lock lever: PES
0.2 mm2 4-core cabtyre cable, 2 m 6.562 ft long
Extension up to total 100 m 328.084 ft is possible with 0.3 mm2, or more, cable.
(Note):Take care that the output voltage drops when the cable is extended.
Net weight: 60 g approx., Gross weight: 100 g approx.
MS-DIN-2 (Amplifier mounting bracket): 1 pc., Adjusting screwdriver: 1 pc.