| | EMC Directive, RoHS Directive | 0.5 sec. or less approx. (±1,000 V → ±100 V) (Note):Typical value for pulse air mode: CONT at 100 mm 3.937 in from the front of discharge nozzle at an applied air pressure of 0.50 MPa. | Air (dried clean air) (Note):Dried clean air is the air passing through air dryer (dew point -20 ℃ -4 ℉ approx.) and air filter (mesh size 0.01 μm 0.0004 mil approx.) | 300 ℓ/min. (ANR) or less | 0.05 to 0.50 MPa | Accessory AC adapter INPUT: 100 - 240 V AC ±10 % 50/60 Hz (OUTPUT: 24 V DC) | 30 VA or less | High-frequency AC method | Pulse 1 (long) / Pulse 2 (short) / CONT (continuous) selectable by switch | ON (always ON) / SYNC (synchronized with trigger) / OFF (always OFF) | Ionized air emission operation ON / OFF using OR control with trigger switch Ionized air emission operation ON: Short-circuited to COM (-) Ionized air emission operation OFF: Open | 0 to +50 ℃ +32 to +122 ℉ (No dew condensation allowed), AC adapter: 0 to +40 ℃ +32 to +104 ℉ | 35 to 65 % RH (No dew condensation allowed) | 270 g approx. (main unit only) | AC adapter: 1pc. Exclusive intermediate cable (oil-resistant, heat-resistant, bending-resistant type) length 2m 6.562 ft: 1 pc. Straight joints ・Tube outer diameter ø8-ø8mm ø0.315-ø0.315 in compatible type: 1 pc. (Note):At the time of shipment from the factory, ø8-ø8mm ø0.315-ø0.315 in type is attached. ・Tube outer diameter ø8-ø6mm ø0.315-ø0.236 in compatible type: 1 pc. Connector connection terminal (Manufactured by Molex): 3 pcs. | Where measurement conditions have not been specified precisely, the conditions used were an ambient temperature of +20 ℃ +68 ℉. |