Laser Measurement Sensors: High Speed, Multi-Point Laser Displacement Sensor HL-D3

Model List

Found 3 matches. Display 1 - 3 matches.
Part No.sort ascendingData SheetCE marking directive complianceMeasurement center distanceHeight (Z axis) measurement rangeMeasurement range of width (X axis) : Near sideMeasurement range of width (X axis) : Measurement centerMeasurement range of width (X axis) : Far sideUnit of measurement output : Height (Z axis)Unit of measurement output : Width (X axis)Resolution : Height (Z axis)Resolution : Width(X axis)Parts Inventory
   Column active Filter
Close

Filter by CE marking directive compliance

Column active Filter
Close

Filter by Measurement center distance

Column active Filter
Close

Filter by Height (Z axis) measurement range

Column active Filter
Close

Filter by Measurement range of width (X axis) : Near side

Column active Filter
Close

Filter by Measurement range of width (X axis) : Measurement center

Column active Filter
Close

Filter by Measurement range of width (X axis) : Far side

Column active Filter
Close

Filter by Unit of measurement output : Height (Z axis)

Column active Filter
Close

Filter by Unit of measurement output : Width (X axis)

Column active Filter
Close

Filter by Resolution : Height (Z axis)

Column active Filter
Close

Filter by Resolution : Width(X axis)

 
design engineersPanasonicHL-D3C
n/an/an/an/an/an/an/an/an/an/a
design engineersPanasonicHL-D301C
EMC Directive, RoHS Directive50 mm 1.969 in±10 mm ±0.394 in11.5 mm 0.453 in12.5 mm 0.492 in12.5 mm 0.492 in0.1 μm 0.004 mil1 μm 0.039 mil (Note):It is a value in which the sensor heads connected to a controller Ver. 2.00 or higher.1 μm 0.039 mil (Note):The value is the average of height measurement in full width at the measurement center distance.5 μm 0.197 mil
(Note):It is a value in which the sensor heads connected to a controller Ver. 2.00 or higher.
(Note)This is the measurement value of a pin gauge rounded surface in the edge position measurement (start of falling edge) calculation setting. The measurement object: white ceramic pin gauge (ø10 mm ø0.394 in), unit light receiving time: 200 μs, measurement value extraction: base light intensity control, average number of samples: 64, width smoothing: ±4, all others are the initial settings.
design engineersPanasonicHL-D301B
EMC Directive, RoHS Directive50 mm 1.969 in±10 mm ±0.394 in11.5 mm 0.453 in12.5 mm 0.492 in12.5 mm 0.492 in0.1 μm 0.004 mil1 μm 0.039 mil (Note):It is a value in which the sensor heads connected to a controller Ver. 2.00 or higher.1 μm 0.039 mil (Note):The value is the average of height measurement in full width at the measurement center distance.5 μm 0.197 mil
(Note):It is a value in which the sensor heads connected to a controller Ver. 2.00 or higher.
(Note)This is the measurement value of a pin gauge rounded surface in the edge position measurement (start of falling edge) calculation setting. The measurement object: white ceramic pin gauge (ø10 mm ø0.394 in), unit light receiving time: 200 μs, measurement value extraction: base light intensity control, average number of samples: 64, width smoothing: ±4, all others are the initial settings.