DPH-L113V
Specification
| Item | Performance characteristics |
|---|---|
| CE Marking Directive Compliance | EMC Directive, RoHS Directive |
| Type of Pressure | Sealed gauge pressure (Note): The sensor's internal mechanism is sealed based on an air pressure of 1,013 hPa. |
| Rated Pressure Range | -0.1 to +1 MPa |
| Pressure Withstandability | 2 MPa |
| Applicable Fluid | Gases and fluids that do not corrode stainless steel SUS630, SUS304, or SUSXM7 |
| Supply Voltage | 9 to 36 V DC [9 to 32 V DC when using the attached connector (e-CON)] |
| Current Consumption | 20 mA or less |
| Analog Voltage Output | Output voltage: 1 to 5 V DC (over rated pressure range) Accuracy: ±1.0 % F.S. (at 23 ±2 ℃ +73.4 ±35 ℉) ±2.0 % F.S. (at -20 to 70 ℃ -4 to +158 ℉) (including linearity, hysteresis and repeatability) |
| Response Time | 1 ms or less |
| Protection | IP67 (IEC) |
| Ambient Temperature | -20 to +70 ℃ -4 to +158 ℉ (No dew condensation or icing allowed), Storage: -30 to +70℃ -22 to +158 ℉ |
| Ambient Humidity | 35 to 85 % RH, Storage : 35 to 85 % RH |
| Medium Temperature Range | -20 to +70 ℃ -4 to +158 ℉ |
| Voltage Withstandability | 150 V AC for one min. between all supply terminals connected together and enclosure |
| Insulation Resistance | 100 MΩ, or more, with 50 V DC megger between all supply terminals connected together and enclosure |
| Vibration Resistance | 10 to 2,000 Hz frequency, acceleration 200 m/s2, in X direction for four hours, in Y and Z directions for two hours each (Note): The X, Y, and Z directions are defined as follows :  |
| Shock Resistance | 1,000 m/s2 acceleration in X, Y and Z directions three times each |
| Grounding Method | Capacitor earth (Enclosure-supply terminal) |
| Pressure Port | R1/4 male thread (throttle embeded) |
| Material | Diaphragm : Stainless steel (SUS603), Pressure port : Stainless steel (SUS304), Throttle : Stainless steel (SUSXM7) |
| Connecting Method | Connector |
| Cable | 0.2 mm2 3-core heat resistant cabtyre cable 2 m 3.562 ft long |
| Cable Extension | Extension up to total 10 m 32.808 ft is possible with 0.2 mm2, or more, cable. |
| Weight (Typ.) | Net weight : 100 g approx., Gross weight : 150 g approx. |
| Accessories | Connector (e-CON) : 1 pc. |
| Remark | Where measurement conditions have not been specified precisely, the conditions used were an ambient temperature of +23 ℃ +73.4 ℉. The sensor head can be used independently. |
| Dummy | CE Marking (EMC Directive, RoHS Directive), UKCA Marking (EMC Regulations, RoHS Regulations) |
Stock Check
Important
The service is owned, operated, controlled and managed by Panasonic's distributors.
For pricing, delivery and technical questions related to this service, please direct to them.
Panasonic assumes no responsibility for any dealings you may have with distributors.
